(Insufficient Charge Warning Function) In such a case, expose your watch to light for a while to cancel the warning. The second hand starts moving at two second intervals in order to warn that the watch will stop functioning after about 1 week. When recharging the watch after it is completely in the stop state, be sure to pull out the crown to the time setting position.Īfter recharging, set the time and push the crown firmly back into its normal position. Time required to charge the watch sufficient for one-day use with one second interval operation. Time required to fully charge when the watch has completely stopped. ![]() To become fully charged when the cell is discharged… The recharging time is the time the watch is continuously exposed to direct light. Illuminance (lx) Charging time (approx.) To work for one day To start working normally when the cell is discharged To become fully charged when the cell is discharged Outdoors (sunny) 100,000 2 minutes 17 minutes 11 hours Outdoors (cloudy) 10,000 11 minutes 2 hours 35 hours 20 cm (7-7/8 inches) from a fluorescent lamp (30W) 3,000 40 minutes 7 hours 120 hours Interior lighting 500 4 hours 50 hours. This table is for general reference only and does not represent exact charging times. TIME REQUIRED FOR CHARGINGīelow are the approximate times required for charging when exposing the watch dial to light continuously. If an alternate cell is installed, such as a conventional battery, the battery may become overcharged resulting in damage to the movement and/or bursting of the cell, which could cause injury to the user. The movement is designed to operate with only the original rechargeable cell. Never allow anyone other than an Authorized Service Center to replace this cell. The energy cell should last the life of the watch. This is a clean energy cell that will last the life of the watch. Unlike ordinary watches, the special rechargeable cell used in your watch does not need regular replacement. Never place your watch on the dashboard or rear deck of a vehicle as the heat generated in these areas can damage your watch. We do not recommend the use of Halogen bulbs for recharging. Be sure to keep the watch at least 50cm (20inches) away from the bulb so no damage occurs. (e.g.) Incandescent lights generate heat sufficient to damage your watch. Notes on rechargingĪvoid recharging your watch in areas of high temperatures (over about 60 ☌ / 140 ☏), otherwise the sensitive components of the watch may become damaged. When you take your watch off, be sure to place it in as bright an area as possible. As such, additional exposure to light may be necessary. Please note that if you wear long sleeves, your watch may be hidden from light and may result in insufficient charging. To maintain optimal performance, be sure to expose your watch to light regularly. CARE AND HANDLING DURING CHARGING Notes on Use Once the special rechargeable cell is fully charged, the overcharge prevention function comes into operation and prevents over-charging of the rechargeable cell. You can recharge your watch without worry (However, the time to start may vary according to the brightness of the light.) Overcharge Prevention Function It will begin to operate soon after it is exposed to light. The watch will stop if it is completely discharged. Even in such a case, the watch keeps correct time, but about 4 days after the two second interval movement begins, the watch will stop.Īfter exposing the watch to light, recharging takes place and the watch returns to one second interval movement. The second hand changes to a two second interval movement to indicate insufficient recharging. If the charge becomes insufficient, a warning function will operate and the display changes, as below. between 9:00 pm and 4:00 am FUNCTIONS OF ECO-DRIVE WATCH Date, day of the week display models ….Otherwise the calendar may not change correctly. Do not adjust the calendar when the watch is reading as below.After you have set the calendar, be sure to press the crown back to its normal position.In the case of date display models, turning the crown clockwise will result in the loose play of the crown.Set the desired day of the week by turning the crown clockwise.Set the desired date by turning the crown counterclockwise.Pull the crown out to the 1st click (calendar setting position).The watch will start after the crown is firmly pushed back into its normal position. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |